G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car.  
This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below. 

The NGTTX [215-4000] is Designed to suit the grey plug RB25DET NEO engine.  

• Please check your connector matches the header in the listed photo before purchasing.  
• This ECU works for manual transmissions only.  
• Most factory features are supported. 
• Note, this ECU does not currently output the 4wd signal required for proper 4wd operation in 4wd Stageas and skylines. 
• Check the features tab for I/O expansion options  

Suitable applications: 
RB20DE NEO, RB25DE NEO and RB25DET NEO in R34 Skylines 

G4X Plug-In Key Features (where applicable):

• Up to 6D fuel and ignition mapping
• Precision closed loop cam control (four cam, independent control)
• Sequential fuel delivery
• Digital triggering, all OEM patterns
• OEM idle hardware supported
• 5D boost control with three switchable tables
• Motorsport features - anti-lag, launch, flat shift
• Continuous barometric correction (on board)
• CAN port
• QuickTune - automated fuel tuning
• Individual cylinder correction
• USB tuning cable included
• Stats recording into on-board memory
• Gear compensations for spark, boost and fuel
• Real time selectable dual fuel, ignition and boost maps
• Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical
• Boost control referenced to gear, speed or throttle position
• 512 mega bytes data logging memory
• Staged injection
• Knock with "windowing"

I/O Expansion Options:
The following expansion connector inputs/outputs are provided: 
Expansion connector 1  
SGnd                Sensor Ground Only  
+5V Out        Low Current +5V Supply 
DI 7                Digital Input 
DI 8                Digital Input 
An Volt 10        Analog 0-5V input 
An Volt 9        Analog 0-5V input 
Ign 7                Ignition 7 Auxiliary Output 
Ign 8                Ignition 8 Auxiliary Output 

Expansion connector 2  
SGnd                Sensor Ground Only  
+5V Out        Low Current +5V Supply 
DI 5                Digital Input 
DI 6                Digital Input 
An Volt 5        Analog 0-5V input 
An Volt 6        Analog 0-5V input 
An Temp 2        Temperature sensor input 
An Temp 3        Temperature sensor input 

Pin 108 – OBD1 wire now used for IAT on Temp 4.